Various turbo parts
#1
Elite Member
Thread Starter
iTrader: (2)
Join Date: Jan 2007
Location: Lexington, SC
Posts: 2,075
Total Cats: 0
Various turbo parts
I have some turbo parts laying around that need a good home. All prices are shipped.
*JAW 1.03 Assembled $80
I have never used this, received it new and it has never touched a wire. Install instructions are available on their website (14point7.com).
Just a heads up,when wiring this up a resistor is needed for the tach signal I believe, as the unit is meant to accept a 0-5V and the Miata has a 12V if I am not mistaken.
Emanage Blue $240
This comes with the support cable. Unfortunately I do not have a hard copy of the software, but it can easily be found online (what I did). I have installed this but it never saw power as I removed it before I finished the miata. It is not plug and play, but it is only a few wires that need to be attached to the ECU. It also includes the instruction manual for both the EMB and support tool, but the support tool manual is in Japanese Included as well is the harness for ignition timing, which is once again just a few wires to hook up. (The other harness seen is the main/injector harness)
Vortech FMU $50
Just your run of the mill Vortech.
O2 Clamp PENDING SALE
An Olderguys (I believe) O2 clamp, comes with pressure sensor. Instructions included. It is located in the EMB picture. (Little Black Box)
1.8 Injectors $40
These are what they say they are, 1.8 Miata injectors. One of the rubber grommets are missing from the top of one of the injectors. The plastic cap is cracked on another. I have never run these, but came from a running miata on this site.
1.6 Manifold PENDING SALE
This is an OBX 1.6 manifold. I have installed it once, but never run the engine with it on.
RX7 MAF $25
An RX7 flap style AFM. This is useful for anyone not running a standalone as it is considerably larger than the Miata unit. I have had the black plastic off, but did not change any of the stock RX7 settings.
*JAW 1.03 Assembled $80
I have never used this, received it new and it has never touched a wire. Install instructions are available on their website (14point7.com).
Just a heads up,when wiring this up a resistor is needed for the tach signal I believe, as the unit is meant to accept a 0-5V and the Miata has a 12V if I am not mistaken.
Emanage Blue $240
This comes with the support cable. Unfortunately I do not have a hard copy of the software, but it can easily be found online (what I did). I have installed this but it never saw power as I removed it before I finished the miata. It is not plug and play, but it is only a few wires that need to be attached to the ECU. It also includes the instruction manual for both the EMB and support tool, but the support tool manual is in Japanese Included as well is the harness for ignition timing, which is once again just a few wires to hook up. (The other harness seen is the main/injector harness)
Vortech FMU $50
Just your run of the mill Vortech.
O2 Clamp PENDING SALE
An Olderguys (I believe) O2 clamp, comes with pressure sensor. Instructions included. It is located in the EMB picture. (Little Black Box)
1.8 Injectors $40
These are what they say they are, 1.8 Miata injectors. One of the rubber grommets are missing from the top of one of the injectors. The plastic cap is cracked on another. I have never run these, but came from a running miata on this site.
1.6 Manifold PENDING SALE
This is an OBX 1.6 manifold. I have installed it once, but never run the engine with it on.
RX7 MAF $25
An RX7 flap style AFM. This is useful for anyone not running a standalone as it is considerably larger than the Miata unit. I have had the black plastic off, but did not change any of the stock RX7 settings.
Last edited by mazda/nissan; 10-01-2009 at 10:10 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Frank_and_Beans
Supercharger Discussion
13
09-12-2016 08:17 PM