AFR issue (LC-1)
11-28-2015, 08:56 PM
#1
Junior Member
Thread Starter
Join Date: May 2011
Location: Signal Hill, CA
Posts: 257
Total Cats: 13
AFR issue (LC-1)
No idea why it's not reading correctly. The brown wire was spliced into the stock o2 sensor wire, then I tried connecting it to pin 10 in mspnp center connector with no luck. LC-1 grounds and ECU ground are in the same location. (cylinder head)
LC-1 Controller was programmed (output 2)
0.0V - 10.0 AFR
5.0V - 20.0 AFR
LC-1 Controller was programmed (output 2)
0.0V - 10.0 AFR
5.0V - 20.0 AFR
Reply
0
0
11-29-2015, 01:25 PM
#3
Junior Member
Thread Starter
Join Date: May 2011
Location: Signal Hill, CA
Posts: 257
Total Cats: 13
It's set to innovate lc-1 default 0-5v lambda at the moment. I've also tried the other options without successes.
-Update-
Switched the gauge to read lambda and it reads fine. Switch the controller setting to Innovated 0-5v 10-20 AFR and the afr gauge in TS is stuck on 10 afr
-Update-
Switched the gauge to read lambda and it reads fine. Switch the controller setting to Innovated 0-5v 10-20 AFR and the afr gauge in TS is stuck on 10 afr
Last edited by .one lane; 11-29-2015 at 03:24 PM.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
Cxmoney
Miata parts for sale/trade
8
12-01-2015 10:00 PM
