I think I may have fried my ignitor
02-18-2009, 11:38 AM
#1
Junior Member
Thread Starter
Join Date: Oct 2007
Location: Livonia, MI
Posts: 105
Total Cats: 0
I think I may have fried my ignitor
so i had my car running with the base map on megasquirt. Then i ran into some trouble were i would load up my msq file and it would say there is a comflict between the controlller file type and the one from megasquirt. it said that "this is usually a very serious problem" then it sad that the file recieved from controller was ">boot....." "terminate megasquirt now?" i hit no by mistake and now the car wont start and it doesnt seemt o recognize the megasquirt at all now. could i have fried the megasquirt? when i turn the key now the car canks but doenst fire. is there a test i can do to see if it fried either the ecu or ignitor? i should of just left well enough alone. 
. also when i tried to reload my firmware, it said that the download failed, the exact same thing happened here:
im almost positive its because of my ******* vista laptop. my concern now though is getting the thing running, or fixed
. also when i tried to reload my firmware, it said that the download failed, the exact same thing happened here:I had a problem with the registry being invalid so i deleted it and remade it so then i got to where i Do this and closed anything that could talk with the megasquirt. This is the result. i selected the correct COM port and i even tried upgrading from the standard megasquirt code and still same response
If you are upgrading from standard Megasquirt code you will need to
use the boot jumper soon. If you are upgrading from Megasquirtnspark,
DualTable, MegasquirtnEDIS or an earlier MSnS-extra this program
will do it for you.
.
If you are unsure then press Y to quit - press Q
.
.
.
. Please read the README file!!!
.
Are you upgrading from standard Megasquirt code [Y,N,Q]?N
.
This should count up to 1700+ lines
.
src\download.exe -c2 msns-extra.s19
MS Download 1.10
Download failed:
Expected response "
Boot>",
but received this "".
Press any key to continue . . .
If you are upgrading from standard Megasquirt code you will need to
use the boot jumper soon. If you are upgrading from Megasquirtnspark,
DualTable, MegasquirtnEDIS or an earlier MSnS-extra this program
will do it for you.
.
If you are unsure then press Y to quit - press Q
.
.
.
. Please read the README file!!!
.
Are you upgrading from standard Megasquirt code [Y,N,Q]?N
.
This should count up to 1700+ lines
.
src\download.exe -c2 msns-extra.s19
MS Download 1.10
Download failed:
Expected response "
Boot>",
but received this "".
Press any key to continue . . .
im almost positive its because of my ******* vista laptop. my concern now though is getting the thing running, or fixed
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
