Rev limiter not working!
#1
Junior Member
Thread Starter
iTrader: (10)
Join Date: Jan 2008
Location: SF Bay Area
Posts: 291
Total Cats: 0
Rev limiter not working!
While tuning over the weekend I noticed my rev limiter is not working. Overboost protection works. Launch control works. Soft cut & hard cut rev limiters do not work. Soft cut is supposed to be at 7200. Hard cut should be at 7300. I can rev easily past 7500 (in megatune) before I let off the throttle.
Has anyone experienced this/know how to fix it?
I've already tried reflashing the firmware to no avail.
Msq & Msl attached in rar file.
Someone help!
Has anyone experienced this/know how to fix it?
I've already tried reflashing the firmware to no avail.
Msq & Msl attached in rar file.
Someone help!
#7
What code are you guys using? I have hr_10g.
Like spookyfish, I've noticed that the rev limiter ends up being 2-300rpm higher than the hard cut... so I just set it a few hundred rpm low.
Right now I have it set to 7400, and it peaks at about 7650. I think I'll reduce the hard cut to 7350....
Like spookyfish, I've noticed that the rev limiter ends up being 2-300rpm higher than the hard cut... so I just set it a few hundred rpm low.
Right now I have it set to 7400, and it peaks at about 7650. I think I'll reduce the hard cut to 7350....
#8
What code are you guys using? I have hr_10g.
Like spookyfish, I've noticed that the rev limiter ends up being 2-300rpm higher than the hard cut... so I just set it a few hundred rpm low.
Right now I have it set to 7400, and it peaks at about 7650. I think I'll reduce the hard cut to 7350....
Like spookyfish, I've noticed that the rev limiter ends up being 2-300rpm higher than the hard cut... so I just set it a few hundred rpm low.
Right now I have it set to 7400, and it peaks at about 7650. I think I'll reduce the hard cut to 7350....
Thread
Thread Starter
Forum
Replies
Last Post
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM
Frank_and_Beans
Supercharger Discussion
13
09-12-2016 08:17 PM