gtred

The car is at my rural vineyard site... so no internet connection. I tried to install a megasqirt, but it did not find firmware. Can i disconnect the ms and bring to a site that i have internet; oor, do i have to have it hooked to the car to download the firmware?

thirdgen

iTrader: (26)

As long as you can supply 12v to the ms, it should load firmware. Otherwise, No.

hi_im_sean

iTrader: (3)

And youll need a good healthy 1A+ supply. I was using a 500mA wall wart when I did this with mine and I chased my tail for hours wondering why it would fail port test. As soon as I hooked up my 5A bench supply, it worked just fine.

Braineack

iTrader: (62)

download the firmware that's loaded on the MS, and point to .ini file when creating a new project in TS.

gtred

I did try this last night and wasn't able to get very far before it got dark.

Under new project, I was able to get it to identify:
MS3 release 1.3.4 2015012315:56GMT(c)jsm.kc

I was unable to successfully browse and load an .ini file

I'll play with it again tonight and see if I can get the project going.

btw, I couldn't resist cranking it just once. It fired right up... then died as no fuel pump.

Braineack

iTrader: (62)

MS3 1.3.4 Release Firmware - Megasquirt EFI