codrus

So I'm trying to put in a set of ISC front UCA offset bushings to add camber. Following their instructions (http://www.iscracing.net/bushinst.html), I got the bushings in, slid the long bolt through, put them in the car, and tightened it down and the control arm binds. Checked the gaps and (leaving out the factory inner washers) there is clearance between the bushing and all of the non-rotating surfaces (outer washers, the ends of the tube on the subframe).

So, stupid question time:

Do these need lube or not? Googling seems to be unclear -- lots of people asking, nothing definitive one way or the other. A bunch of references to delrin being "self-lubing"? No lube included in the ISC package, none mentioned in the instructions. They come with zerk fittings, are those just for location, or also for lube access?

--Ian

Rennkafer

iTrader: (3)

I made my own Delrin offset bushings and they definately needed to be lubed. If they included zerk fittings I'd say ISC thinks so too.

It also appears from ISC's instructions that you have to ream the busing bores to size after you install the bushings in the control arms.

You should be able to just barely turn the sleeves in the bushings by hand and there shouldn't be any slop.

codrus

OK, I reamed out the bushings some more (had done them a bit before, but not enough apparently), lubed 'em up with the silicone stuff, and now they move smoothly. Thanks!

--Ian

Clos561

iTrader: (3)

i would almost always lube up bushings or anything liek that becuase they will constantly have friction and that could lead to cracking or faster wear.

Gotpsi?

iTrader: (5)

You can buy bushings that do not require lube, in the heavy equipment industry they are starting to go this route. The metal bushing and pins are pre-impregnated with oil, its cool stuff.

haubi

Hey do you still have the measurements for the offset bushings? I'm looking into making some myself.

thanks