90-93 Toyota COP mounting plate
#1
Junior Member
Thread Starter
iTrader: (3)
Join Date: Apr 2008
Location: Marietta, Ga
Posts: 223
Total Cats: -1
90-93 Toyota COP mounting plate
I'm in the market for a 1.6L miata Toyota COP mounting plate. I have seen a lot of you guys had several lot cut on water jet, so I was wondering if anybody had an extra lying around they would like to sell?
#3
Former Vendor
iTrader: (31)
Join Date: Nov 2006
Location: Sunnyvale, CA
Posts: 15,442
Total Cats: 2,099
I've never seen any waterjetted, but ours are stamped out of 1/8" aluminum with studs pressed into place. I've yet to see a cleaner solution.
Shoot me a PM with a Paypal address and I can invoice you for one - they are $50 shipped in the lower 48 states.
Shoot me a PM with a Paypal address and I can invoice you for one - they are $50 shipped in the lower 48 states.
#4
Junior Member
Thread Starter
iTrader: (3)
Join Date: Apr 2008
Location: Marietta, Ga
Posts: 223
Total Cats: -1
You've never seen a waterjetted one? Have you read through the 69 page cop thread? Lol, I scan through the thread to look for images. A few guys have had a few sets water jetted. I can make my own with a hole saw, I was looking for something cleaner.
#6
Cpt. Slow
iTrader: (25)
Join Date: Oct 2005
Location: Oregon City, OR
Posts: 14,181
Total Cats: 1,133
Something cleaner that's going to be covered up? You can see only one cut edge on mine (same design as above) where I cut it to length. If you can't do that cleanly you have problems.
And watch your attitude.
And watch your attitude.
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM