tach problems.
 

I did an engine rebuild on my car due to rod failure and a huge hole in the block. I swapped all sensors over from my old block to the new one with the exception of my knock sensor. Now my problem is that my tachometer on my dash doesn't seem to function properly above 1,200 rpms. Now, the guages on adaptronic (F2) doesn't seem right either. My car sounds like its only at 1000 rpms, yet registers on adaptronic's guages around 16xx rpms. Is there like a tachometer sensor on the car that might be screwing with both? I'm completly stumped on this one.

Is the engine running well?
Ted

the engine is running a little rough at idle right now. still working on tuning. everthing after idle and taking off is gravy, but running super rich and killing my gas millage. Every time I go to take off from a stop, the car will sound like a tommy gun and it seems like it miss fires. This only happens when I am letting off the clutch and giving it gas, and it happens no matter what gear I am in. Unfortunatly today the miata left me stranded. The dipstick was low, I didn't realize I had an oil leak from my drain plug bolt. There was however still some oil on the dipstick. It was on the very bottom of the lower line of the stick. I'm not sure if this can cause my car to not start, or if it was from fouled plugs. I'm guessing it was a combination of both. The starter is completly gone and will not even click over. I manually turned the crank and checked to see if my rods and pistons were still in one piece, thankfully they were. But some other things I realized today, I forgot to put in the thin peice of sheet metal that goes inbetween the transmission and the engine block :vash:. This has a ground strip and I dont know if this contributes to a part of the tach being off. I drove through some gravel today and i'm not sure if a piece of gravel entered my bell housing, which kinda worries me. But another question I had was, would low oil cause my engine to suddenly hessitate and bog down? Or is this another problem I am faced with? I noticed that after i drove on gravel that my engine bogged down tremendously. It was fine before i hit the gravel road but all the while I was still somewhat loosing oil.

I suggest one or both the crank angle and cam angle sensors are loose or not instilled as per Mazda specs. The ecu is not getting reliable and good quality pulses from the sensor. Worth a check though and the plug and socket of the sensor to.
Ted

thanks ted. Ill double check that. I thought the cam sensor only installed one way, one angle. Im not so sure about the crank sensor though. Ill give it a look today. Thanks again