Cost Estimate
#1
Junior Member
Thread Starter
iTrader: (2)
Join Date: May 2007
Location: Tulsa, OK
Posts: 181
Total Cats: 5
Cost Estimate
I'm very close to pulling the trigger and ordering the Adaptronic, but I wanted to know if there any other expenses I should plan for.
I've added an extra $150 to budget for fouling plugs, and just the random
**** that projects always require. Wideband not included in this estimate.
Vehicle: 2004 MSM
I can use the stock IAT from what I've seen, correct?
Any other sensors that I'll need to purchase?
Going to run stock injectors for about a month (270's), and then upgrade to something else.
If I use the electronic boost control, can I manipulate boost creep?
What's the delivery time frame? a week? a month?
Any mounting brackets, or did everyone just fab something up?
I've browsed these forums off/on for awhile now, and finally decided I had to have one! So I'm sure they'll be some "I'm an idiot and the car won't idle" thread in awhile.
TIA
I've added an extra $150 to budget for fouling plugs, and just the random
**** that projects always require. Wideband not included in this estimate.
Vehicle: 2004 MSM
I can use the stock IAT from what I've seen, correct?
Any other sensors that I'll need to purchase?
Going to run stock injectors for about a month (270's), and then upgrade to something else.
If I use the electronic boost control, can I manipulate boost creep?
What's the delivery time frame? a week? a month?
Any mounting brackets, or did everyone just fab something up?
I've browsed these forums off/on for awhile now, and finally decided I had to have one! So I'm sure they'll be some "I'm an idiot and the car won't idle" thread in awhile.
TIA
#4
Junior Member
Thread Starter
iTrader: (2)
Join Date: May 2007
Location: Tulsa, OK
Posts: 181
Total Cats: 5
I appreciate the feedback.
What about parts to do the sensor calibrations? Will I need anything to calibration the map (+/- pressure)?? Air tank/Vaccum pump??
This IAT
http://www.diyautotune.com/catalog/g...tail-p-62.html
This Boost Solenoid
http://www.diyautotune.com/catalog/e...kit-p-285.html
Those two parts are correct?
What about parts to do the sensor calibrations? Will I need anything to calibration the map (+/- pressure)?? Air tank/Vaccum pump??
This IAT
http://www.diyautotune.com/catalog/g...tail-p-62.html
This Boost Solenoid
http://www.diyautotune.com/catalog/e...kit-p-285.html
Those two parts are correct?
Thread
Thread Starter
Forum
Replies
Last Post
Jike Spingleton
Cars for sale/trade
3
09-20-2016 04:33 PM