05MSM no sync on EMS-4
04-16-2015, 08:23 AM
#1
Senior Member
Thread Starter
iTrader: (10)
Join Date: Aug 2007
Location: Fredericton, NB
Posts: 1,186
Total Cats: 4
05MSM no sync on EMS-4
HELP...need to drive this car right now but won't even start.
Car was just switched to sequential BUT it`s only running a 12tooth(old style Trackspeed wheel).
I turn off cam MX (missing tooth), turn on cam count (pattern strategy) as Sav recommended but he also mentioned manually setting the phasing...is someone running this setup as it`s over my head at that point.
attached cal and log while cranking
Car was just switched to sequential BUT it`s only running a 12tooth(old style Trackspeed wheel).
I turn off cam MX (missing tooth), turn on cam count (pattern strategy) as Sav recommended but he also mentioned manually setting the phasing...is someone running this setup as it`s over my head at that point.
attached cal and log while cranking
Reply
0
0
04-16-2015, 08:47 PM
#2
Junior Member
Join Date: Oct 2011
Posts: 109
Total Cats: 0
HELP...need to drive this car right now but won't even start.
Car was just switched to sequential BUT it`s only running a 12tooth(old style Trackspeed wheel).
I turn off cam MX (missing tooth), turn on cam count (pattern strategy) as Sav recommended but he also mentioned manually setting the phasing...is someone running this setup as it`s over my head at that point.
attached cal and log while cranking
Car was just switched to sequential BUT it`s only running a 12tooth(old style Trackspeed wheel).
I turn off cam MX (missing tooth), turn on cam count (pattern strategy) as Sav recommended but he also mentioned manually setting the phasing...is someone running this setup as it`s over my head at that point.
attached cal and log while cranking
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
