Preluding

iTrader: (10)

I've just wiring in a knock sensor from a old Saturn to my AEM EMS.

I've done a run at low boost and determined what I believe is the knock floor.

I really want to create "knock" just too see what the logs look like. Is this safe?? I was thinking of just revving the car in neutral at about 4k and continue advancing the timming until I see the voltage spike as well as start to hear sound from the knock muffs.

What do you think?

JasonC SBB

It'll be hard to make it knock with light load.

Try advancing it lots at 3500 kPa and 100 kPa. Drive on a flat road and hold the RPM at 3500, then roll into it. As the car transitions through 100 kPa it should knock once or twice. Do it with the engine hot.

Preluding

iTrader: (10)

thanks, I'll raise it up a few degrees at 100kpa and do runs progressively until I see a spike in the knock voltage

ForAllMankind

what you could also do it tap on the block near the knock sensor while at RPM.

J&S safeguard they make individual cylinder knock sensor and timing control their website may be of help, as how to test for knock

ForAllMankind

you want to make sure the the knock sensor is working first, hence tapping the block and etc.