Drift car from MA
Thread Starter
Junior Member
Joined: May 2014
Posts: 349
Total Cats: 59
From: MA
Winter is getting closer, and the seasons come to an end. Time to start driving in the basement.
If anyone plays the game and wants to join a weekly league, I set one up with a buddy. Search for the league name "Drift Faction" (two words).
If anyone plays the game and wants to join a weekly league, I set one up with a buddy. Search for the league name "Drift Faction" (two words).
Last edited by robertw; Nov 26, 2015 at 09:16 AM.
Reply
0
0
Thread Starter
Junior Member
Joined: May 2014
Posts: 349
Total Cats: 59
From: MA
Before I put the car away
Street Car Interior by superkamikazee, on Flickr
Done for the year, in the shed it goes.
Winter is Coming by superkamikazee, on Flickr
Street Car Interior by superkamikazee, on FlickrDone for the year, in the shed it goes.
Winter is Coming by superkamikazee, on Flickr
Last edited by robertw; Dec 13, 2015 at 03:23 PM.
Reply
0
0
Thread Starter
Junior Member
Joined: May 2014
Posts: 349
Total Cats: 59
From: MA
Old photo re-edit.
Before
After
Got some time on my buddies lift today. Buttoned up a few loose ends from last year, primarily the under tray. Intercooler and piping made this fun.
Oil temps were climbing a bit after a few laps drifting at the last event without the under tray and the plastic shroud in the bumper. So hopefully this helps direct some more air flow through the radiator to keep temps in check. I might cut the hood to let some hot air out as well.
Before
After
Got some time on my buddies lift today. Buttoned up a few loose ends from last year, primarily the under tray. Intercooler and piping made this fun.
Oil temps were climbing a bit after a few laps drifting at the last event without the under tray and the plastic shroud in the bumper. So hopefully this helps direct some more air flow through the radiator to keep temps in check. I might cut the hood to let some hot air out as well.
Reply
0
0
Thread Starter
Junior Member
Joined: May 2014
Posts: 349
Total Cats: 59
From: MA
Installed a Mishimoto catch can, not the prettiest setup, but it should function. I'm going to try finding a 90 degree fitting for the outlet on the catch to clean things up. Previously I was just running a breather filter off the valve cover.
Reply
0
0
