Aidan's loose oily bunghole actually runs a track lap
#1061
SADFab Destructive Testing Engineer
Thread Starter
iTrader: (5)
Join Date: Apr 2014
Location: Beaverton, USA
Posts: 18,642
Total Cats: 1,866
<p>Did I just pull an <span>@Leafy?</span></p><p>
</p><p>Driveshaft spins when in gear, but theres a clunking noise and the wheels don't move. I cant spin the driveshaft by hand.</p>
#1071
Mine popped off as well when I removed my axles. Just bought some good quality Moly grease, removed the old, smeared new grease in, tapped end plates back on.
I hear it is unwise to put grease in like this though, apparently you want a "right" amount. I couldn't find the answer to that so I just said **** it and reinstalled. No problems after 10k so...
Also depress the collar, clean the bearing, and slip it back in no harm no foul.
I hear it is unwise to put grease in like this though, apparently you want a "right" amount. I couldn't find the answer to that so I just said **** it and reinstalled. No problems after 10k so...
Also depress the collar, clean the bearing, and slip it back in no harm no foul.
#1079
SADFab Destructive Testing Engineer
Thread Starter
iTrader: (5)
Join Date: Apr 2014
Location: Beaverton, USA
Posts: 18,642
Total Cats: 1,866
Good to hear. I'll clean these up and probably keep them as spares. Do you know if they are the same side to side?
<br />
<br />Also, are 1 piece axles interchangeable with the 2 piece.
<br />
<br />Also, are 1 piece axles interchangeable with the 2 piece.