Aidan's loose oily bunghole actually runs a track lap
#883
SADFab Destructive Testing Engineer
Thread Starter
iTrader: (5)
Join Date: Apr 2014
Location: Beaverton, USA
Posts: 18,642
Total Cats: 1,866
Originally Posted by Racer Parts Wholesale
Aidan,
Hand tight and 1/4 to 1/3 a turn (somewhere in the range of 8 ft. lbs.)
Regards,
Racer Parts Wholesale
Hand tight and 1/4 to 1/3 a turn (somewhere in the range of 8 ft. lbs.)
Regards,
Racer Parts Wholesale
For the next person searching:
Mocal Thermostat Plate 1/2 inch BSP fitting torque value AN
#888
SADFab Destructive Testing Engineer
Thread Starter
iTrader: (5)
Join Date: Apr 2014
Location: Beaverton, USA
Posts: 18,642
Total Cats: 1,866
Did some more EBC tuning. Also logged some 0-100 pulls.
0-60: 5.5ish
0-100: 13.2ish
Played with launch control. Retarded timing after launch, going to try upping the boost target at launch but right now it kind of hooks, chirps and then goes.
0-60: 5.5ish
0-100: 13.2ish
Played with launch control. Retarded timing after launch, going to try upping the boost target at launch but right now it kind of hooks, chirps and then goes.
#895
SADFab Destructive Testing Engineer
Thread Starter
iTrader: (5)
Join Date: Apr 2014
Location: Beaverton, USA
Posts: 18,642
Total Cats: 1,866
Well there is a planned MS3E but is still stuck getting licensing figured out.
https://www.mslabs.gr/mslc.html
https://www.mslabs.gr/mslc.html
#896
SADFab Destructive Testing Engineer
Thread Starter
iTrader: (5)
Join Date: Apr 2014
Location: Beaverton, USA
Posts: 18,642
Total Cats: 1,866
Might be a silly question. But how do I know if I have enough oil after installing an oil cooler. I was always taught to check oil cold after its all drained into the pan. But I need more than what would normally be in there right? So do I check it while its running?
#897
SadFab CEO
iTrader: (3)
Join Date: Sep 2012
Location: your mom's house phoenix, AZ
Posts: 4,560
Total Cats: 1,142
didnt even notice the E
on the contrary, this will make it read high.
correct
never do this on any engine. with oil being slung all over the place you will get crazy readings.
let the engine idle for 30 seconds, kill it and immediately check it. everything will be as close to their dynamic states as possible without the engine running. at least thats how id do it.
correct
never do this on any engine. with oil being slung all over the place you will get crazy readings.
let the engine idle for 30 seconds, kill it and immediately check it. everything will be as close to their dynamic states as possible without the engine running. at least thats how id do it.
#899
SadFab CEO
iTrader: (3)
Join Date: Sep 2012
Location: your mom's house phoenix, AZ
Posts: 4,560
Total Cats: 1,142
having thought about it, once you know its filled up the right level, you can get a reading once all the oil has drained back, and just keep mental note of that mark as the "cold" level.