Just another turbo miata
#41
Junior Member
Thread Starter
iTrader: (1)
Join Date: Jul 2010
Location: Louisville, KY
Posts: 194
Total Cats: 0
After the next dyno if the car survives I will grab another 1.6 and do a small build of the motor. I am still rocking the 1.6 open diff. I have all the parts needed to do my 1.8 rx7 clutch type diff. I will get that soon. Maybe a winter project or sooner if the stock rear takes a dump. I may upgrade the brakes and suspension. It has aftermarket front an rear sway bars, I have no idea what they are. I haven't looked into them much. I purchased the car from a auto auction would have been cool to meet the previous owner. It was obviously well taken care of.
#42
Junior Member
Thread Starter
iTrader: (1)
Join Date: Jul 2010
Location: Louisville, KY
Posts: 194
Total Cats: 0
Something I have been messing with, this picture below was taken with my iphone this is the unedited photo.
This is the photo after a app called color splash:
This is the photo after camera+
This is the photo after a app called color splash:
This is the photo after camera+
#46
Junior Member
Thread Starter
iTrader: (1)
Join Date: Jul 2010
Location: Louisville, KY
Posts: 194
Total Cats: 0
Yes I answered ya! Chris Ludwig mounted it but I do believe that it come with a bend in it from gm if not u could bend it in a vice. There where some flaps he cut off while where mocking it up. He has done all the work with them.
#55
Junior Member
Thread Starter
iTrader: (1)
Join Date: Jul 2010
Location: Louisville, KY
Posts: 194
Total Cats: 0
Nice to see you again!
Been awhile on here. I haven't really done much with the miata besides just put miles on it. Last weak the high pressure oil line feed to the turbo sprung a leak but it was caught before anything was hurt. Getting a new one made this week. Hopefully my next post will be a 300whp dyno plot from the greddy 15g
#58
Junior Member
Thread Starter
iTrader: (1)
Join Date: Jul 2010
Location: Louisville, KY
Posts: 194
Total Cats: 0
I am using a 1 going to switch to a 2 pre compressor. I am using a 2 pre tb I have the nozzles for a 3 and a 4 to test with any configuration.
Last edited by PatrickB; 11-22-2011 at 09:21 AM.
#60
Junior Member
Thread Starter
iTrader: (1)
Join Date: Jul 2010
Location: Louisville, KY
Posts: 194
Total Cats: 0
Woot! Got it out and going this weekend. Gotta replace the aem 02 sensor already, boo. Ordering some ID's and replacing the 950cc haltechs. May also order some tires and start getting the diff replacement in motion, would like to hit a autocross event or two this summer.