When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I am in Jacksonville and usually goto the FIRM in Starke, FL. they have open track days once a month, good price ($200) and LOTS of track time.
last time i been there, i went through 2 FULL tanks of gas and over 120 miles of on track time, they had about 15 cars show up and just did open track all day instead of groups.
Went ahead and paid to become a supporter of the site. Pretty much all my thoughts, ideas, and plans have come from reading other's threads here so I figured I should give back for those helping me along here. My stupid *** wouldn't be this far without everyone's input.
Totally, this site has been a big help for me too.
A couple new parts showed up...part of my turbo setup from TSE. Still awaiting the rest of the kit which I believe Andrew said would be available early September. Also ordered a TSE radiator. Excited for the parts to show up...the wait continues. Going to pick up the BMW transmission tomorrow. Found a 80K mile one for 275$.
Picked this up today for 275$. Out of a Z3 with 80K miles. Not a small initial investment but nice that the transmissions are easy to find and cheap as **** to replace. Plan to clean it up tomorrow.
Last edited by TonyMontana; 08-16-2017 at 09:07 PM.
I'm kinda bummed you're doing all this great work to a turdy head and IM
I thought about it...reality is for now its fine. I know based on the other parts I'm buying it seems odd but for now it'll work for me. Plus it'll leave me something to upgrade in the future. Im sure when i explode this motor ill do a full VVT build with a flattop manifold, cams, and the like. Im the typical get bored with something and need to upgrade so that'll be next.
Cant MUCH more material be taken out of the center, leaving a "knife edge?" Any subaru pnp head I've seen (most mod knowledge is from subaru) has the knife thang hapnin
Cant MUCH more material be taken out of the center, leaving a "knife edge?" Any subaru pnp head I've seen (most mod knowledge is from subaru) has the knife thang hapnin
Probably on a full race head which the machine shop offered but I didn't opt for.
And I thought I spent a good chunk of change on my build... I'm just waiting for you to get a VVT in your next update.
I started reading this website when I was 24 and was borrowing money like a mother ****** for school. Im 33 now so it's been a long wait to get here but I figured for me and my OCD if I was going to build the car I was going to do it the best I could. Its a fair bit of change but I figure its cheaper than drugs and women. Keeps me out of trouble.
08-10-2017, 12:38 AM
0
