1992 red turbo NA, super clean, lots of goodies
 

SOLD SOLD SOLD

I've spent the last 4 years building Rocinante, and it has been an amazing dual purpose street/track car. Alas, my track ambitions include racing and I don't want to trash this car up with full cage etc., so I'm going to sell and replace it with full racecar build.

Super clean, dead reliable, and ready to give someone else a million smiles. Drive it on the country roads. Drive it to the track and humiliate some Porsches and Mustangs, then drive it home.

https://cimg6.ibsrv.net/gimg/www.mia...2633859f4e.jpg
https://cimg9.ibsrv.net/gimg/www.mia...fccb8cc05b.jpg
https://cimg1.ibsrv.net/gimg/www.mia...a826fc29c6.jpg
https://cimg7.ibsrv.net/gimg/www.mia...1e00110561.jpg
https://cimg4.ibsrv.net/gimg/www.mia...7fa104fbdf.jpg

Build details:Basics/Maintenance

- 152,000 base package car. Garage kept its entire life until about 3 months ago

- Clean Carfax, never wrecked or damaged. Clear title.

- Zero rust, good original paint.

- Timing belt, water pump, cam seals, front crank seal, CAS o-ring, valve cover gasket, shifter rebuild done at 135,000 miles.

- Clutch replacement at 139,000 miles with Exedy Stage 1 clutch. Replaced pilot and throwout bearing, rear main seal, cursed water plug. Motor mounts replaced with Mazda Competition.

- Oil changed with Rotella T6 every 3-4k miles.

- Transmission fluid and differential fluid replaced annually.

Frame/Chassis/Suspension/Brakes

- Hard Dog Hardcore X-braced roll bar with SFI padding and vinyl cover, Hard Dog harness bar. Mounting points for six point harness are already installed, all you need is the seat and harness.

- Original Mazda hardtop, AND soft top in perfect condition.

- Xida GS suspension with less than 5k miles.

- Konig Dial-In 15x8 wheels with one year old Hankook RS4 tires, lots of tread left.

- Trackspeed Engineering front Big Brake Kit; Wildwood Dynalite front calipers, brand new PFC 97 compound front brake pads, Wildwood 2 piece 11.75” front rotors.

- Trackspeed Engineering rear caliper relocation kit with Sport rotors, PFC 97 compound pads

- Trackspeed engineering stainless steel brake lines

- Wildwood brake proportioning valve

- Flyin Miata frame rails

- Bauer extended lower ball joints

- Front hubs and bearings replaced with Centric “premium” (no machined step), ARP wheel studs

- Rear hubs and bearings replaced with SadFab MR2 hubs, ARP wheel studs

- Supermiata aluminum lug nuts.

- Track alignment done at Gran Turismo East (Atlanta)

Drivetrain

- Stock 1.6L motor with 170+ compression on all cylinders

- MKTurbo kit with T3/T4 turbo, Vibrant 12800 intercooler, 2.5” piping all the way to throttle body.

- MegaSquirt PNP2, wired for sequential injection, manual boost control. Pro tuned at DBW Motorsports; 205whp, 196wtq on Mustang dyno.

- SuperMiata radiator

- M-Tuned coolant reroute

- 4.1 Torsen limited slip differential

- Lots of custom heat shielding for track reliability

Interior

- NB2 “surfboard” seats. Driver side foamectomy and rear humps removed to accommodate tall drivers.

- Great audio system. Pioneer Bluetooth head unit, Kenwood digital amp, Focal speakers, JL subwoofer in custom passenger footwell enclosure.

- Momo steering wheel, Daikei hub adapter, NRG quick release

- Boost and wideband gauges in A pillar

Lots and lots of other stuff, and a bunch of spares too.

I have over $23k invested in this car. Priced to sell at SOLD!

Great car, great seller. I'd buy this car if I didn't already have two turbo Miatas. GLWS!

Does this car have A/C? I'm guessing not based on the fan knob, but just wanting to clarify.

It was a base model from the factory, so no A/C, power steering, or power windows.

An updated interior photo. You can just see the subwoofer enclosure under the passenger floor mat. I still have the driver side door handle, just took it off because I'm tall and it gives me more leg room.

https://cimg3.ibsrv.net/gimg/www.mia...0b7787a4c4.jpg