SPEEDSTER44

iTrader: (1)

Does somebody knows where I can get a 3" downpipe that is bolt on for a td04h from greedy. I have a 2.5" form turbo tony but is not enough to get 300hp with it.

thanks

SKMetalworks

iTrader: (7)

Greddy turbo will not support 300 hp.

p51hellfire

iTrader: (28)

triple88a

iTrader: (2)

i agree with the above. LoL however to answer ur question i believe begi makes custom 3" dps

SPEEDSTER44

iTrader: (1)

my turbo is upgraded with 19t wheel and right now I j=have 260 rwhp so I think going 3" downpipe and exhaust can help me get a few more hp considering that I have 8psi of back pressure in my 2.5 downpipe

18psi

iTrader: (76)

you have 8psi of backpressure? You MEASURED back pressure in your exhaust?

SPEEDSTER44

iTrader: (1)

yes this way you can know if the air that is coming out of the turbo has an easy way out of is struggle by the size of the downpipe and exhaust

viperormiata

iTrader: (24)

LOLOLOLOLOLOLOLOLOLOLOLOLOLOLOL

triple88a

iTrader: (2)

how do you know its not ur cat or ur muffler causing the pressure? I have hard time believing 8 psi is caused by a 2.5" dp.

SPEEDSTER44

iTrader: (1)

to measure that simply had put a fitting in the o2 bung that i can plug to the dyno where it checks the psi the same place you get the pressure coming of the turbo and do a run and then you know how thing are going at the back.

2 or 3 psi is the highest pressure we should get to to optimize the turbo


thanks

SPEEDSTER44

iTrader: (1)

i was open exhaust

triple88a

iTrader: (2)

ah i see. Well like i said call begi and see what they can do for ya. Hopefully they can help you out.

SPEEDSTER44

iTrader: (1)

you can laught but not a lot of people has come with 260rwhp here with greddy turbo and manifold I must not be completly wrong

SPEEDSTER44

iTrader: (1)

thanks triple88a

18psi

iTrader: (76)

post your dyno sheets and setup.

SPEEDSTER44

iTrader: (1)

https://www.miataturbo.net/forum/t41007-2/

SPEEDSTER44

iTrader: (1)

go there and clic the pdf file this was 15 psi run

i have 262 with 3 more psi but can't my dawm dyno sheet

viperormiata

iTrader: (24)

We're just giving you a hard time man. With the 19t and enough boost, you should be able to hit the mark your looking for.

I remember a thread about a 1.8 miata, using the ETD manifold, hitting over 280whp.

ARTech

iTrader: (34)

I pretty sure I can make it for you. The first bend would have to start out at 2.5" since there's very little clearance to the shelf, then flare to 3" after. PM me if interested.

p51hellfire

iTrader: (28)

less donk rims, less restricting grill mesh, more boost, less greddy, less gay hood, more coin and you has it
Artech is the bomb btw he can and will make u anything even a 3" strap on... lol