Toddcod

iTrader: (8)

I have to get the car running tomorrow. Either I'm going to drive without IC for a while, or I have to get it tommorow. i have the old school FM steel tubes. It looks like 2 inch ID piping.
Thanks for pictures , diagrams, or hot chicks.

TurboTim

iTrader: (9)

Go thru the fender. 2.5"







2" with the old starion I/C:

y8s

iTrader: (8)

not quite as nice as Tim's but...

http://gallery.y8s.com/miata/turbo/intercooler/

m2cupcar

iTrader: (5)

Tim - is that just 2.5" 90* bend through the fender?

levnubhin

iTrader: (30)

Tim, hows that intake working for ya? I've been thinking about doing the same.
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote

TurboTim

iTrader: (9)

Yes, with another angle at the very end right in front of the tire. But the bend in question is a 90deg tight radius 2.5" from ATP. Fits without hitting/rubbing on the fender. Actually fit better than the standard radius Vibrant 2" pipe.

miatamoxie

iTrader: (1)

Here's the pics I've got on my computer here at work of my install. I don't have any detail shots of the cold side not installed, and I don't have any really good shots of the hot side installed, but here is what I do have:

Engine overview (somewhat shows hotside routing):


Hotside before install:


Coldside from intercooler:


Coldside to throttle body:

TurboTim

iTrader: (9)

OK I guess. The fuel map now requires a very strange dip around 3500rpm, like there's some sort of resonance going on and a lot less fuel is required. The fuel map based on the OEM manifold was very rich. But it keeps the IAT's low and was good practice welding aluminum for something usefull. I may hacksaw off the OEM TB flange and go with a cheap mustang 65mm eventually, the only thing really holding me back from doing that is it is a real PITA to get to the mounting nuts on the head. I did make 271rwhp with this manifold though.

johndoe

iTrader: (5)

thread jack: are those the A/C lines or PS lines you have shielded at the compressor. It's hard to tell. If it is A/C is this advised?

y8s

iTrader: (8)

I forget but it's probably both. they were real close to the manifold.

Braineack

iTrader: (62)

Toddcod

iTrader: (8)

Thanks for the pictures! My hotside is jacked up. There is a local place that sells high temp silicone hoses for $3.00-5.00 per foot. I'm going to intragrade it in.
TurboTim what do you charge for an IC setup?

TurboTim

iTrader: (9)

I charge what most consider a lot.