sulimanister

Hey guys,
I'm building a 97' turbo miata and i'm looking to save a little bit of cash on the ECU department.
instead of getting a full blown programmable ecu i wanna get the apexi s-afc to control the fuel and the bipes to control the timing.
any of you guys had/has experience with these 2 little puppies put together?
can i even install them side-by-side?

Thanks

Braineack

iTrader: (62)

shouldn't be a problem. but a full blown megasquirt setup will run your close to the same $$$.

SamS

iTrader: (2)

As far as I know, they don't share any of the same wires. It should work fine, though most people just use an FMU to raise fuel pressure and Bipes for timing, or an ecu that controls both.


...I do have a used Bipes in the for sale section though. :gay:

Edit: The safc and Bipes do both share the air flow wire, but that shouldn't be an issue anyways

o.e.boost

i was going with this setup, but the cost is exactly what brain said...close to a mspnp!!!...but if you have a safc just get the bipes and your set!!!...

Braineack

iTrader: (62)

not mspnp.


diy MS. I've been providing them to members here for under $450.

sulimanister

thank you for you replies.
the mspnp is not compatible with the 97' model as far as i know. am i right?

@Braineack: is your diy ms compatible with the 97' model?

Thanks Again.

Braineack

iTrader: (62)

yes, and mspnp 96-97 is coming soon.