ARP head stud install issue ?
Putting engine together. Installed arp studs and torqued head to 65lbs. During torquing i felt my wrench slip a few times as the washer rotated.
Arps included instuctions say to lube the washer/threads/nut with arp lube before torquing Im seeing threads online (none miata related) that say arp lube shouldnt be used on the clyinder side head of the washer ? Should i pull them off one at a time and clean lube off washer and retorque ? Or is the washer slipping normal ? |
Washer slipping is normal. Just torque to 60ft/lbs and you’re good. I always lube both sides of the washer too.
|
I went arps instructions and went 65ftlbs. I rechecked torque after last pass of 65 and none of them moved
|
All times are GMT -4. The time now is 07:36 PM. |
© 2024 MH Sub I, LLC dba Internet Brands