coltonr

so turns out the I/c I bought used along with my bov etc etc is faaaar to big to try n fit with the na bumper and actually have fit.
However I did get a ton of clamps and silicone coupler's so I was wondering.if people could.post up some pictures of their ic setups keeping both p/s and ac. I was thinking.of running the pipe straight down from the throttle body then around the radio and AC and then into the ic and then having the other side come straight up over the top in a setup like this because there is virtually no room to come up by the ps.

Let me.know and pics would be immensely helpful upon searching I haven't found crap and.I'm looking for something.very specific

Braineack

iTrader: (62)

what size IC do you have?

coltonr

[QUOTE=Braineack;931307]what size IC do you have?[/QUOT

i dont have the exact measurements but lets put it this way its big enough to cover the entire radiator. For 200whp its to big and the overheating issue is not something i wanna deal with.

Im looking to run something abround 18in or smaller this way i can run the ic setup i mentioned

Braineack

iTrader: (62)

if you're too lazy to measure. I'm too lazy to help.

coltonr

touche, it is from endtank to endtank 31x12x3

Braineack

iTrader: (62)

yeah that's quite large.

IIRC my core is 18x6x2.5. You can fit the 18x12x3 core if you offset the IC next to the dryer. otherwise, you'll have to go under it or smaller/offset.

coltonr

what company is the core your running?? ive found a couple but none look like that one and can you send me some pics of your piping route?
running it off center is fine i expected to have to

Braineack

iTrader: (62)

cxracing.

coltonr

the ones im finding only the IC is 18in with the end tanks it ends up being around 26in

coltonr

cxracing.com: Universal Intercooler 19.5"x6"x2.5", 2.5" Core: 12"x6"x2.5", 2.5" Inlet&Outlet, B16 B18 B-Series

this is the smallest 2.5In they have. this isnt the same measurements but its close

coltonr

also brain can you post up some piping routing pics when u get a chance

Braineack

iTrader: (62)

are you even trying?

here are the two posted above:

cxracing.com: Front Mount Intercooler 25"x12"x3", 3" Core: 18"x12"x3", 2.5" Inlet & Outlet

cxracing.com: Universal Front Mount Tube & Fin Intercooler 18"x12"x3", 3"Core, Mustang Ford Honda Civic Nissan



the one i'm currently running i got for like $40 on ebay. but I'm not entirely happy with it. It doesnt controll the delta as much as even teh 12x13x3 and it getting banged up pretty bad by rocks.

coltonr

whoops im looking at the 2.5in thickness not the size of the endtanks thats why i was not geting those. hmmm i shall have to decide atleast cxracing stuff is affordable im guessing your running bar and plate not the tube and fin setup

Braineack

iTrader: (62)

mines tube and fin right now.

lighter and flows air through it better, but less rigid and unsure if more efficient after comparing the like.

coltonr

hmmm alright ya i was doing some research and they say the internal dynamics of the bar and plate are better but they supposedly dont pull as much air into the ic as the tube and fin design does.