wastegate sensor location
#1
Senior Member
Thread Starter
iTrader: (6)
Join Date: May 2009
Location: San Francisco
Posts: 983
Total Cats: 23
wastegate sensor location
So the problem is that my wastegate that is supposedly set at 8 psi is only giving like 4-5. The internal wastegate line is connected to the compressor housing. I can think of a few reasons for this, and think moving the line to be connected to the intake mani would fix it. So i went back to maximum boost by corky to see what it says, and it says moving the line over to the cold side of the intercooler causes a large wave of heat(air) through the whole setup until the wastegate gets opened.
So where are your internal wastegates hooked up to?
I also just got the ebay MBC in the mail that i'm going to hook up, should i move the line or just keep in in the same place and use the MBC to get my correct pressure?
So where are your internal wastegates hooked up to?
I also just got the ebay MBC in the mail that i'm going to hook up, should i move the line or just keep in in the same place and use the MBC to get my correct pressure?
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM
Greasyman
General Miata Chat
2
09-28-2015 10:44 AM