No i had to lower the radiator, only about 2 inches i think.

hmmm....I would do this but then again I dont want to cut the hood

Pics of the bottom?

pakman this is more complicated then i thought

why not just 2" all around? I have 2.5 all around and when I upgrade any part of this setup its getting stepped down to 2" for clearance around stuff.

Why discard the starion ic??? It is perfect for this route...
Mount it upside down and cut the pipes 1.5" from the end tanks...

Nope I just cut the tabs off and welded them on lower down.

that's what I did. but my setup is pretty ghetto, so no pics :p

Not really.

Here's how I did it on my NB: (I think this also applies to NA, but not sure?)

Drill out holes in the lower rad brackets to fit the lower sway bar mounts.
http://memimage.cardomain.net/member...5_110_full.jpg

Install in lower holes:
http://memimage.cardomain.net/member...5_111_full.jpg

Fab new upper rad brackets to angle the rad back:
http://memimage.cardomain.net/member...5_112_full.jpg

Completed Turbo:
http://memimage.cardomain.net/member...5_127_full.jpg

time to fab a panel for the gap.

what's the biggest size intercooler we can fit? i'm thinking of the same setup for the intercooler

found

for a rx7, if it fits, this should do fine

or a starion

http://cgi.ebay.com/ebaymotors/Stari...QQcmdZViewItem

seems like a modified starion would be perfect, just need to find where/how to get/fab the pipes, i think the rx7 one is too big

any pictures of how the starion is held onto the chassis?