first turbo build, 1990 1.6L miata
have papers where it was rebuilt at around 140,000 miles
im going to check compression and make sure its a good engine tomorrow racing beat side skirt, fenders, new top, red leather interior, adjustable cam gears, and its a LOT slower than my 93 that had the 1.8 swap in it. i dont know why, it has full adjustable suspension, lowering springs, has a lot of stuff done racing beat maf and racing beat intake, rx7 spoiler, just some basic info about it ^^ but i want to just run 4-5 pounds of boost and i would be happy, just want something thatll give me a little more power and make it a little more fun to drive so turbo mani/downpiep/turbo and pipe to intake ild imagine whats cheapest build i can do? any advise, never had a turbo car before |
My single best piece of advice- delete this thread and read up for a few weeks.
If you don't, they will rape you like a house cat in here. |
I made a similar thread not too long ago (albeit I wasn't afraid of the shift button, it wasn't my 1st post, I bothered to read up before posting, and I asked more specific well thought out questions), but they still ate me alive. They told me to do myself a favor and get the Begi-S kit, they will tell you to do the same.
Here is a link to the thread I made asking the same basic question: https://www.miataturbo.net/showthrea...ght=obligatory |
|
OP don't post back in this thread go to the noob section and post up. Then do a shit load of searching. If you keep at this rate they will ban you or you will get your ass put in your mouth by Hustler or one of the other noob PWNing members.
YOU HAVE BEEN WARNED!!!! |
Originally Posted by Gearhead_318
(Post 744669)
I made a similar thread not too long ago (albeit I wasn't afraid of the shift button, it wasn't my 1st post, I bothered to read up before posting, and I asked more specific well thought out questions), but they still ate me alive. They told me to do myself a favor and get the Begi-S kit, they will tell you to do the same.
Here is a link to the thread I made asking the same basic question: https://www.miataturbo.net/showthrea...ght=obligatory I can't believe I was the last one to post in that thread by gearhead. |
oh schnap!! lol
where can i do some research at, any sections on this forum? with used parts whats the cheapest build youve seen? |
Read the stickies, in fact read all the stickies on this sight.
The aforementioned Begi-S is cheap and meets your goals. No, you can not get an ebay kit that will work, and I highly doubt you could do a DIY kit that would be cheaper and not kill your engine. Edit: Maybe the Shanghai-S would work: http://www.bellengineering.net/produ...roducts_id=396 |
All times are GMT -4. The time now is 11:41 PM. |
© 2024 MH Sub I, LLC dba Internet Brands