wrapping up my 1.8 swap, a few stray wires
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Aug 2008
Location: Evansville, Indiana
Posts: 314
Total Cats: 0
wrapping up my 1.8 swap, a few stray wires
on the passenger side of my motor, there are two grounds that i'm not sure where they're supposed to go. can i just ground them on the chassis wherever? there's also a single wire black spade connection, pretty sure it's a ground as well, any idea where this goes?
#2
Single black wire with the spade is for the temp sensor for the cluster and it goes under the cai (real bitch to get to), as for the grounds...they should all go to the same place on the engine I believe which is on the passenger side. There is a little bracket on the back of the intake manifold with a 10mm nut on it. Throw the grounds on there.
#3
Junior Member
Thread Starter
iTrader: (1)
Join Date: Aug 2008
Location: Evansville, Indiana
Posts: 314
Total Cats: 0
Single black wire with the spade is for the temp sensor for the cluster and it goes under the cai (real bitch to get to), as for the grounds...they should all go to the same place on the engine I believe which is on the passenger side. There is a little bracket on the back of the intake manifold with a 10mm nut on it. Throw the grounds on there.
Only thing that comes to mind is cold air intake. I don't have one of those.
#7
Junior Member
Thread Starter
iTrader: (1)
Join Date: Aug 2008
Location: Evansville, Indiana
Posts: 314
Total Cats: 0
i was thinking about this at work today...
there's a bracket that bolts to the thermostat housing on the back of the head with a male spade connection on it. is this where the gauge reads the temp from?? seems like a **** poor spot for it.
there's a bracket that bolts to the thermostat housing on the back of the head with a male spade connection on it. is this where the gauge reads the temp from?? seems like a **** poor spot for it.
Thread
Thread Starter
Forum
Replies
Last Post
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM