jwarriner

For those of you who actually have one...

In your opinion, is there enough clearance to run these two parts off the turbine:

V-band adaptor from ATP with 3" 90 degree low-profile downpipe.

Thanks.

Braineack

iTrader: (62)

what runner is the flange on?

jwarriner

According to the pic in this thread (which, oddly, is the only pic I've been able to find of the 1.6L HKS) it's the middle. Which is probably bad.

EDIT: Actually, unless it's an illusion, it appears to be slightly offset to the front, but if so, it's not by much.

Braineack

iTrader: (62)

probably be close with the flex, without it, I'd think it would fit no problems....if anything you can just trim the shelf out a bit and really take care of the heater hoses and brake master.

Stripes

iTrader: (8)

If I were to guess, I would say there is not enough clearance. If there is room, it would be an extremely tight fit.

greddymx5

iTrader: (1)

il motorsport in germany makes a t25 downpipe for the hks miata mani...

http://www.ilmotorsport.de/shop/arti...627152f7c1c514

email me for pics of the hks turbo set....(i have a lot of pics)

jwarriner

I tried to e-mail you but it said you didn't want to receive e-mails. Mine is jwarriner@gmail.com and I'd love to see any pics you have time to send me.

Al Hounos

check my vbgarage if you want to see how much clearance there is.

jwarriner

That tells me all I need to know, thanks!

Stripes

iTrader: (8)

I forgot I had some DP pics posted in my vb garage. This gives you an idea of what a 2.5 inch pipe would look like in a 1.8. I've since made a divorced version. I'll post some pics later.

Braineack

iTrader: (62)

exactly. I knew one of you guys had done exactly what I was talking about...couldn't remember who.

greddymx5

iTrader: (1)

Thanks, adjusted profile....