turbo flange questions
#1
turbo flange questions
Ok, I am going about this backwards, but I have an older log mani and dont know what type of turbo fits it, it has no markings, etc.
There was a link (6mos or 1 year ago) that had the whole page of flanges with their measurements. I have been to the jgs page and atp. The flange I need is 1/4 inch shorter than the kt010 (gt25 or 15) or whatever.
Anyone recall the link?
I have searched over 400 threads and the google, but still haven't found this elusive link.
There was a link (6mos or 1 year ago) that had the whole page of flanges with their measurements. I have been to the jgs page and atp. The flange I need is 1/4 inch shorter than the kt010 (gt25 or 15) or whatever.
Anyone recall the link?
I have searched over 400 threads and the google, but still haven't found this elusive link.
#3
really
Really? Ok.
Outside measmts (edge to edge)
width 3 and 9/16 (or 3.5625)
high 2 and 1/2 (or 2.5)
[dont let the above measurements fool you - wait for the below]
bolt measurements [edit from centre of bolt to centre of bolt]
width 2 and 7/8 (or 2.875)
high 1 and 5/16 (or 1.3125) **
gases holes (or oval or whatever at the largest part)
width 2 and 1/4 *
high 1 and 1/4**
* is off by less than 1/4
** is off GT25 by more than or equal to 1/4 inch
Outside measmts (edge to edge)
width 3 and 9/16 (or 3.5625)
high 2 and 1/2 (or 2.5)
[dont let the above measurements fool you - wait for the below]
bolt measurements [edit from centre of bolt to centre of bolt]
width 2 and 7/8 (or 2.875)
high 1 and 5/16 (or 1.3125) **
gases holes (or oval or whatever at the largest part)
width 2 and 1/4 *
high 1 and 1/4**
* is off by less than 1/4
** is off GT25 by more than or equal to 1/4 inch
Last edited by gamman; 03-08-2007 at 05:22 PM.
Thread
Thread Starter
Forum
Replies
Last Post
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM