my custom manifold
#1
Junior Member
Thread Starter
Join Date: Apr 2009
Location: Auckland, New Zealand
Posts: 50
Total Cats: 0
my custom manifold
ok this is my first post and my first turbo mx5 so here is the manifold i made yesterday its all out of 3mm steam pipe i welcome your comments (not that im gonna change it) but i would like to know what you all think
i have mounted the turbo high and out from the no2 cilinder, so have added some extra length to the front two pipes to try to keep them evenish i have gone with a 4-2-1 setup with it
i have mounted the turbo high and out from the no2 cilinder, so have added some extra length to the front two pipes to try to keep them evenish i have gone with a 4-2-1 setup with it
#12
I think it's a long angle on the photo, and he's probably just a couple of inches forward of a standard cast mani with the flange centered between 2 and 3.
I might be a little high to put up there though with the slope of the hood, and he surely won't have PS. Making a 3" DP would be easier though.
I might be a little high to put up there though with the slope of the hood, and he surely won't have PS. Making a 3" DP would be easier though.
#20
Junior Member
Thread Starter
Join Date: Apr 2009
Location: Auckland, New Zealand
Posts: 50
Total Cats: 0
come on guys i need my beauty sleep
i will be using a t25 turbo i am still running my PS but no ac
my intercooler pipe will go down behind the ps pump (pretty tight bend)
there is plenty of room behind the turbo for the down pipe i will be using 2.5 inch for that
braineack is correct with his diagrams i have never seen a manifold like this before so i too will be interested in how it goes
i will be using a t25 turbo i am still running my PS but no ac
my intercooler pipe will go down behind the ps pump (pretty tight bend)
there is plenty of room behind the turbo for the down pipe i will be using 2.5 inch for that
braineack is correct with his diagrams i have never seen a manifold like this before so i too will be interested in how it goes