Help with Bipes please
I installed my Bipes ACU in my '96 this afternoon, following the instructions. When I got it all connected, I turned the key and all I got was cranking, the engine won't start. With key on, all lights on Bipes are lighted, no matter what display mode it's in.
I tried hooking the two CAS wires into the CAS IN on the Bipes, but still only cranking. I hooked my CAS wires back together as they were stock, to bypass the Bipes, and the car starts, but idles very rough, and smokes a little. I also got a P0340 CEL, Crank Position Sensor System Malfunction. Does this mean I have to replace my CAS??? **EDIT** CEL went away, car still idles like crap, but acts normal with throttle **EDIT** |
Make sure your conections are tight ESPECIALLY the main plug from the box!
I had trouble with this for a long time before i realized what it was. Goodluck! This might help https://www.miataturbo.net/forums/showthread.php?t=2597 |
Alright, I'll try checking the connections again, thanks.
|
Check that you didn't reverse the CAS-in CAS-out wiring. It could be that you have them backwards... car won't start, but will turn over with it configured like that....
Dave, |
:rolleyes: Well, I figured it out....
I had the Bipes turned upside down so that I wouldn't get confused by up being off, and down being on with those switches. Thing is, I then put all the wires in backwards. :rolleyes: Once I finally figured that out, car runs like a dream. Thanks guys! SamS |
hi there... I have a question completely out of scope but what made you choose the bipes over an e-manage? thanks for helping out a newbie!
|
Originally Posted by Sk8te
hi there... I have a question completely out of scope but what made you choose the bipes over an e-manage? thanks for helping out a newbie!
|
Originally Posted by sunbrn
Cheaper, easier to install, doesn't require a computer
|
All times are GMT -4. The time now is 11:15 PM. |
© 2024 MH Sub I, LLC dba Internet Brands