sickmiata09

ok heres the deal: 99 miata with 460cc injectors, s-afc2, and a diy turbo kit. I wired the s-afc today and tried it. everything seems to work well except that with the car off it shows the air flow to be 100%. I called apexi and double checked my wiring and everything looks good. If any of u s-afc users had this problem how did u over come it. Plz help im so close to completion.

magnamx-5

iTrader: (7)

it is the setting for your afm confirm you have the correct sensor type selected and either up voltage or down voltage, i dont know what the NB sensor is though. This is purely a settings issue.

sickmiata09

how do u select an up or down voltage?

sickmiata09

the up or down voltage is only for throttle. that I have squared away. when i plug in my scanner tho it says that there is no air passing through the maf. do I need to wire in a resistor like u emanage guys or (as I suspect) is my maf gone.

magnamx-5

iTrader: (7)

no go to the etc seection like i said and change the voltage for the AFM the TPS should be set to nothing * if you have a manual 1.6. I had to do it on mine becouse the default showed maxed flow voltage when no flow existed it is in the manual and flow chart they gave you when you bought the safc. for real man i wouldn't lie to you or make this up.

sickmiata09

dude in my eyes ur helpin me out an there is no way i think that ur lying to me. But how is it that when i plug in the shp scan tool and view data it shows that my maf is sucking in nothing. also in what section of the manual is this procedure located in.

magnamx-5

iTrader: (7)

ok go to etc you will see the sensor check option check there i cant find the map that shows how to do the changes, the manual doesnot mention it either but i know ive done it if all else fails reboot will refresh the settings as well. Are you pluging in a scan tool to see the AFM flow or the safc you do know the safc stays hooked up or the car wont run. Right? First i would try the reset and or find the chart of all the stuff you can do. then try a sensor check and i know there is a sensor setting for other than TPS.

sickmiata09

thanx... yea i kept the s-afc plugged in srtarted the car with the scan tool and the afm shows no air being sucked in through it. ill try doing as u described thanx

magnamx-5

iTrader: (7)

also what does the safc read in the monitor part for Airflow?

sickmiata09

it reads 100% always thats wat started this whole ordeal for me.