Help with my diypnp
So I just got done assembling my diy, I installed the firmware and it works on my pc what I'm wondering is if I did the wiring correct (the adapter board) and the jumper cables. Please help and if it is correct can I just plug it in and load there map
https://cimg9.ibsrv.net/gimg/www.mia...7fbc8a9d3.jpeg https://cimg0.ibsrv.net/gimg/www.mia...0357ef5d3.jpeg |
youre missing the idle fly-back diode and vr and opto pull-up resistors. Bottom right of second shot under NITROUS INPUT
at a quick glance it looks good, I'd personally remove FP from the HIGH SIDE DRIVER and connect it straight to 4O. Then using spare wire, make a small bridge between the 2O pin on the AFM connector and the FP Relay pin. you need to remove the variable resistor on R19. |
https://cimg9.ibsrv.net/gimg/www.mia...c6373030e.jpegThis is the board without the micro squirt
https://cimg0.ibsrv.net/gimg/www.mia...b9fcc7ba10.jpgThese are the resistors and diodes I had said So I will remove the r19 resistor right I was also told to remove the r39 as well where can I find the idle fly back diode spot I have one diode left and it said extra where do I add it to exactly I also have the 3 470ohm resistors for pull ups is that the ones I have to solder onto the vr and opto sports you pointed out |
https://cimg9.ibsrv.net/gimg/www.mia...c42a6bfcd4.pngGod this phot from online is this correct on the resistor and diode
|
im sorry i meant r39, not r19
yes, that's how youll set them up. are you not looking at the how-to documentation on diy's website? |
Yes. I looked over them that's how I got the connections o was just asking for Someone to double check my connections
|
All times are GMT -4. The time now is 12:27 PM. |
© 2024 MH Sub I, LLC dba Internet Brands