Holset hx30
 

Hello, I have a 1995 1.8. It currently running a China turbo setup t25 flange with 3inch homemade exhaust. I have a Holset hx30 brand new. I have decided I just want ultimate spool with around 300bhp. I am going to put some rods in the engine and oil pump ect supporting mods. I would like to know how this turbo compares to the popular Garret 2554 and 2560 turbo's

I think this is what Aidan once ran on his 1.6, made 250 iirc with good spool. You'd have to get his attention for actual numbers though. If my memory is correct, those numbers on a 1.6 would indicate it's much closer to a 2560. I'm not sure it'll net you your 300hp however.

I wanted to run one, never could find one used though. On a 1.8 and pushing the turbo hard i think 300+ would be possible.

I went EFR instead because I hate my wallet.

TD04L-15G from a Volvo.

Thanks for your help. So what you are saying i am better off keeping my hx30 then buying the gt2860r?

old 2860R or GTX2860R?

Both will do the 300hp job, but its not even near "ultimate spool".

if you have some money to burn, go with the new Garrett G series and be the beta guy for us :likecat:

I was looking at the gt2860 then buying a billett compressor wheel to basically make it a gtx. What would be ultimate spool?

I say run the hx30 if you have it. I want to see someone run one.

Apparently the g series still underperforms compared to the efr series.

just get the efr 6258 and easily run 300whp with excellent transient boost response (the best in the biz because integrated bpv, which cant be copied) and boost threshold as low as 2000rpm.

Personally I would just run a 2560R they will get you an easy 250-275 whp with good spoolup and itll mate right up to your existing manifold and downpipe

I would like efr 6258 but they are alot of money. I have seen how good they can be with Greg peters using one on his car. I am thinking of just running hx30 turbo due it not being oversized like i thought it was. I also like the vband on the exhaust side as the garrett flange is a pain plus i can have the option of a screamer pipe. Hx30 is also a bit different from the norm of garrett.