LC-1 Question
#1
LC-1 Question
Hey, just wired up my LC-1 and have a quick question:
When I first turn the key to acc for power to the gauges, the LC-1 gauge will flash a constant 7.4 until the sensor element warms up completely (which is a couple of minutes) then it will go to the solid appropriate open air numbers. Is this normal? I'm fairly certain I did the open air calibration, but I burnt up the LED that came with the kit (it was a low voltage LED and I, brilliantly, put it up to a 9v battery to make sure I had the anode/cathode sides correct and it sizzled).
TL;DR: How long does your lc-1 take to warm up and for the gauge to show the appropriate reading.
Thanks a bunch
When I first turn the key to acc for power to the gauges, the LC-1 gauge will flash a constant 7.4 until the sensor element warms up completely (which is a couple of minutes) then it will go to the solid appropriate open air numbers. Is this normal? I'm fairly certain I did the open air calibration, but I burnt up the LED that came with the kit (it was a low voltage LED and I, brilliantly, put it up to a 9v battery to make sure I had the anode/cathode sides correct and it sizzled).
TL;DR: How long does your lc-1 take to warm up and for the gauge to show the appropriate reading.
Thanks a bunch
#3
Elite Member
iTrader: (10)
Join Date: Jun 2006
Location: Athens, Greece
Posts: 5,976
Total Cats: 355
Anywhere from 30 seconds to 1 minute, depending on whether the car is already warmed up or not, running or not running, etc. It should be reading full lean (ie 22.4) if the car hasn't been running for more than say, 20 hours or so.
Thread
Thread Starter
Forum
Replies
Last Post
bigmackloud
Miata parts for sale/trade
19
01-08-2021 11:24 AM
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM