DIY Turbo Discussion greddy on a 1.8? homebrew kit?

STILL having problems with the car

Thread Tools
 
Search this Thread
 
Old 11-28-2007, 06:11 PM
  #1  
I'm Miserable!
Thread Starter
iTrader: (5)
 
bryantaylor's Avatar
 
Join Date: Dec 2006
Location: jacksonville, fl
Posts: 1,711
Total Cats: -1
Default STILL having problems with the car

set-up is: 13g running 9-10psi. small front mount, 2 inch charge pipes going to 2.5 just before the throttle body. 255 fuel pump. cartech FMU, 2.5inch downpipe. AEM wideband.

what is wrong: basically, runs like ****. i did have 310cc out of a 89 probe gt, they had a square connector, so i spliced in the new plugs. the car was VERY rich all the time, even with the fmu adjusted so the bleeder is all the way out and the center screw just barley in. random studder and bog. HORIBLE gas milage got 100 miles for 3/4 tank. i tried adjusting the AFM by the screw and the clock spring, and wasnt getting any results. the screw would help idle some, but the clockspring would have no affect at all. the car also will idle how ever it wants to, sometimes it will idle near stoch, sometimes very lean, sometimes rich.

i have tried: rx7 afm - no change
replaced the plugs and O2 sensor each 3 times - no change
swaped 2 different sets of stock injectors - runs a tad better, but now its lean everywhere most of the time. fmu is set where bleeder is all the way in and the center screw is adjusted in a bunch more (50 ish base psi.) but it will randomly go real rich or real lean. for example, it usually cruises about 14:1 but will randomly go to about 10:1. when you lean into the gas, it will go to like 15-16:1. when you go WOT, it will stay lean and then drop to about 12.5:1-13:1, but half the time it will just stay lean while under a WOT run.

i really am baffled on this. i have took apart the CAS and cleaned it up with carb cleaner, still no difference. i have also took apart the coilpack and cleaned up all the connections on it, still, no help. the car has NO CEL on and when i run the codes, nothing comes up. any ideas on what else i can check or any ideas on what could be the possible source of the problem?
bryantaylor is offline  
Old 11-28-2007, 06:28 PM
  #2  
Guest
 
krayzrac3r's Avatar
 
Join Date: Mar 2006
Location: So Cal
Posts: 407
Total Cats: 0
Default

the walbro 255 is overkill and unnecessary....almost everyone runs a 190. (as stated in scotts turbo FAQ) Might be the problem but im no genius
krayzrac3r is offline  
Old 11-28-2007, 06:53 PM
  #3  
I'm Miserable!
Thread Starter
iTrader: (5)
 
bryantaylor's Avatar
 
Join Date: Dec 2006
Location: jacksonville, fl
Posts: 1,711
Total Cats: -1
Default

it has been in for a long time, ran fine all motor and on a 75 shot. and by a fuel pressure guage the pressure is right on.
bryantaylor is offline  
Old 11-28-2007, 07:34 PM
  #4  
Boost Czar
iTrader: (62)
 
Braineack's Avatar
 
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,493
Total Cats: 4,080
Default

does is run on stock injectors and AFM....start eliminating sources of badness.
Braineack is offline  
Old 11-28-2007, 07:38 PM
  #5  
I'm Miserable!
Thread Starter
iTrader: (5)
 
bryantaylor's Avatar
 
Join Date: Dec 2006
Location: jacksonville, fl
Posts: 1,711
Total Cats: -1
Default

Originally Posted by Braineack
does is run on stock injectors and AFM....start eliminating sources of badness.
kinda. stock injectors and afm are in right now, but still have the lean and random rich condition as listed above.
bryantaylor is offline  
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
ReallyRottenTurbo
MEGAsquirt
4
09-22-2015 12:49 PM
vehicular
General Miata Chat
12
09-14-2015 03:17 PM
bigben
Race Prep
16
09-11-2015 03:41 PM
AlwaysBroken
Engine Performance
5
09-06-2015 12:53 AM



Quick Reply: STILL having problems with the car



All times are GMT -4. The time now is 01:19 AM.