Vortech FMU Ratio
#1
Newb
Thread Starter
iTrader: (1)
Join Date: Nov 2008
Location: San Antonio TX
Posts: 25
Total Cats: 0
Vortech FMU Ratio
I searched for a while and couldn't find an answer to my question.
So i'm in the process of finishing up my turbo set up and i was wondering what ratio i would need with my set up. I ran the numbers in the formula in the DIY FAQ and the 10:1 seemed what i would need at 110 psi but i need some help from you guys.
Here's my set up:
1.8 injectors (tan top)
stock fuel pump
T25 at 7 psi
I know, i know, MS is the way to go but that's just not feasible right now. Trust me it will happen eventually. But for now i'm just gonna run the vortech unit.
So what ratio FMU do you think i need and should i be okay with the stock fuel pump?
So i'm in the process of finishing up my turbo set up and i was wondering what ratio i would need with my set up. I ran the numbers in the formula in the DIY FAQ and the 10:1 seemed what i would need at 110 psi but i need some help from you guys.
Here's my set up:
1.8 injectors (tan top)
stock fuel pump
T25 at 7 psi
I know, i know, MS is the way to go but that's just not feasible right now. Trust me it will happen eventually. But for now i'm just gonna run the vortech unit.
So what ratio FMU do you think i need and should i be okay with the stock fuel pump?
#3
I searched for a while and couldn't find an answer to my question.
So i'm in the process of finishing up my turbo set up and i was wondering what ratio i would need with my set up. I ran the numbers in the formula in the DIY FAQ and the 10:1 seemed what i would need at 110 psi but i need some help from you guys.
Here's my set up:
1.8 injectors (tan top)
stock fuel pump
T25 at 7 psi
I know, i know, MS is the way to go but that's just not feasible right now. Trust me it will happen eventually. But for now i'm just gonna run the vortech unit.
So what ratio FMU do you think i need and should i be okay with the stock fuel pump?
So i'm in the process of finishing up my turbo set up and i was wondering what ratio i would need with my set up. I ran the numbers in the formula in the DIY FAQ and the 10:1 seemed what i would need at 110 psi but i need some help from you guys.
Here's my set up:
1.8 injectors (tan top)
stock fuel pump
T25 at 7 psi
I know, i know, MS is the way to go but that's just not feasible right now. Trust me it will happen eventually. But for now i'm just gonna run the vortech unit.
So what ratio FMU do you think i need and should i be okay with the stock fuel pump?
Don't forget to retard your timing about 1 degree off stock for each psi of boost.
Thread
Thread Starter
Forum
Replies
Last Post
graexodus
Miata parts for sale/trade
9
10-25-2015 03:34 PM
Motorsport-Electronics
ECUs and Tuning
0
09-05-2015 08:02 AM
Ben
Miata parts for sale/trade
4
11-02-2006 01:56 PM