i jock y8s style.
and post DLL power graphs
http://wewt.net/gallery/forum/dyno-chart.gif Still playing with boost levels.. still rocking stock clutch.. :o |
how many boosts is that?
|
I'm guessing low for the turbo- peak torque at nearly 6k seems real late.
What smoothing level are y'all using for the power graph? |
Smoothing of 6, which is the DLL default.
10-11psi, I need a better boost controller, I think it peaks at 11.2 and falls to like 10.3 and kinda spikes a little here and there which gives you the "waves" from 6200 to redline. My boost controller is currently a "dial a bomb", aka a pressure regulator for a air compressor. I need to decide if I want the boost selonoid for the Hydra, or if I want a AEM tru boost, since my autometer boost gauge reads 12psi when the Hydra says 8psi. |
My DLL power graphs from the Link aren't nearly as smooth at 6. I can only assume this is because the hydra has higher resolution - ?
I'm using the home depot style mbc. The spike and fall gets worse as the boost goes up. With the mbc and and helper spring I can dial in perfectly flat boost at ~ 9-10psi. Raise the boost to 15 and I get a 15 spike that falls to low 13. Adjusting the MBC will reduce the drop, but add a rise to the end. I think this all surrounds the use of an internal gate- at least in my case. |
my boost gradually increases a psi on a homemade MBC:
https://www.miataturbo.net/braineack/log/12psi.jpg |
I think what causes part of my problem is running a much larger compressor with the t3 turbine and internal gate. I bet if you had a t4 compressor you'd get the spike.
btw- I'm not exactly sure how MLV determined your min boost higher than the max. Can you add gridlines to that graph with inidicators? I guess tho, it wouldn't work because it just randomly plots each data line - ie: your boost and AFR would be intersecting around boost areas. Does MS use AF targets for autotuning? |
it says -12.479 (like 25.4 ~HG.)
yeah it can...i have them set, but it's only making about 1-2% corrections in cruise only. you can also see the leans spikes on that run....they were tuned out... |
I ordered the hydra boost control from FM today. Should be here later in the week.
|
I gotta figure out the MS boost control mod and wire mine up. I have the solenoid for it.
|
I have a solenoid... but my boost controller chip is bad. :sadwavey:
|
All times are GMT -4. The time now is 02:26 PM. |
© 2024 MH Sub I, LLC dba Internet Brands