LC-1 Install w/ stock sensor wiring??
 

I cannot seem to figure out how to wire the LC-1 through the stock O2 sensor wiring. I have searched around but dont really see anything except the direct conection to the center connector on the MSPNP 94-95. Someone wrote that you can splice into the stock pink wire but after looking there is a red (maybe pink) wire on the computer side of the stock O2 connector (not on the sensor side). Should I tap my brown analog output into this location? If so then do I need to tap into any of the other wires, cut any others, or disconnect the old sensor (i assume so). Any help would be great because I am trying to get the car running today.

And I am not talking about using the old sensor, just to clarify.

Well, I finally found the answers, this is for a 1995 miata, and read about their UEGO installation.

http://www.sportcompactcarweb.com/pr...vii/index.html