LM programmer problem?
I'm sure this question has already came up before,
so feel free to say the usual "Search" response if you must. I did do some searching, but I didn't spend my usual 5 hours searching for this one. Just not in the mood. My LC-1 gauge has been reading 22.4 when I'm in gear and off throttle(that's a whole different question I actually will do some research on), but I set my LM programmer for 0-5v = 10-20afr for both outputs. Wouldn't that mean the max my gauge would show is 20:1 ? Well I got on LM programmer and click the "Use AFR" button and type 10 & 20 on in the appropriate box on each tab and hit program. Then if I open it again both output tabs are back on the "Use lambda" button. I already downgraded to the 1.0 firmware thinking that might solve the problem, but the same thing happens... Is this supposed to happen ? Thanks for your time! |
All times are GMT -4. The time now is 08:56 PM. |
© 2024 MH Sub I, LLC dba Internet Brands