jayc72

iTrader: (14)

The washer fluid bottle on the NA ABS cars is relocated to the front bumper area. Has anyone had trouble routing their I/C piping on the hotside because of this? Looks a little tight, but I've yet only given it a quick look.

People with ABS care to chime in?

Jay

brgracer

iTrader: (14)

I've had three different IC setups with the front washer bottle without a problem so I can't imagine that it'd be an issue UNLESS you are trying the over the rad and into the holes where the washer fill spout comes up.

jayc72

iTrader: (14)

Thanks Tom.

Braineack

iTrader: (62)

i went right under it, no issues:



you could also be dumb like me and use a huge 180° bend.

cardriverx

iTrader: (12)

I took mine off for ease of install, never got around to putting it back in.. but it will fit tightly.

RSV-95

Had to remove mine because it interfered with the intercooler pipe routing on my BEGI S-2 system. I asked Corky if he had any suggestions and shortly afterwards I find this in the mail. Haven't installed it yet but it sure is pretty. I'm sure if you needed it he could fab something up.