Need ideas mounting IWG actuator
 

All,

I have a GT2860RS, FM manifold, and TDR i/c which requires the compressor outlet to point up.

I need ideas mounting the (internal) wastegate actuator, short of fabbing a custom bracket. (Or ideas how to do that easily).

The compressor outlet is in the way, and the canister needs to be mounted at an angle. There are 2 possible positions for the can:

1) far away and low ... a straight actuator rod will work, and I just need an extension from ATP turbo (local). I prefer this option but bracket will be more difficult to fab.

2) closer but high ... actuator rod needs to bend down towards flapper valve which means $80+ for an actuator with a bent arm ... actuator can needs to sit at a pretty sharp angle i.e. its rod axis is not parallel to turbo shaft

Photos of both positions below.


https://www.miataturbo.net/attachmen...ine=1442943643


https://www.miataturbo.net/attachmen...ine=1442943643

Photos are busted...

--Ian

impossible without either custom bracket or welding on mounts to the compressor cover

see here:
https://www.miataturbo.net/build-thr...6/#post1184810

or
Garrett Actuator Wastegate Bracket SR20DET s13 s14 S15 GT25R GT2860RS 71R GTX28R | eBay

Hmm the first ebat link above will position the actuator up high and will require an actuator with a bent arm.

The 2nd one might have worked but it will hold the actuator at the wrong angle.

i was looking for something more like this for cheaper:

ATP Wgt 027 Wastegate Bracket for GT25R GT2554R Turbo | eBay


https://www.miataturbo.net/attachmen...ine=1443008435


that should be able to mount it just like this:



https://www.miataturbo.net/attachmen...ine=1443008435

I dont see any problem with that angle whatsoever.


but you might need to fab something to mount the way i illustrated, i think this one mounts differently on teh front of the compressor, not the rear plates that hold the housing to the backing plate.


need to find this one:


https://cimg9.ibsrv.net/gimg/www.mia...3678e30675.jpg

maybe FM or Begi has old stock of them from really early kits?

Gt2860rs and similar had bent arms from Garrett. Just get the right arm.