I recently dived into the world of forced induction and bought an mtxl plus wideband and found out it had no narrowband output. Can I run MS2 without a wideband at first start? If not, should I reprogram the wideband to see only narrowband to calibrate it first before installing MS2?
Also, can I tap the stock crossover tube with an IAT sensor? Because I don't have an intercooler yet. If not, can I run MS2 on the stock AFM until then? I've heard that it doesn't give off correct data.
Thanks, '92 na
install your wideband and ms2 at the same time. Research on this site how to setup wide and. Its very easy. Wire up the IAT sensor and lay it in the airbox until you get your turbo sorted.