Oil feed adapter, 10MMx1.5MM to -3AN
Impossible to find? I've spent an hour trying to find this adapter for my setup and I'm losing hope. I've found 10x1.5 to -4AN link but I would prefer to run without a second adapter. I know I could run a -4AN line as an oil feed but I'd feel better with -3 and no restrictor. Any thoughts?
|
Go here: AN PLUMBING.COM Earls performance products, Hose ends Hose,Adapters, fittings
Get P/N 593-03CH or 599-03CH or (etc), plus P/N 977520. |
I don't see it on their webpage as just the fitting anymore, but www.stealthmodeperformace.com had -3AN when I was looking for -4AN. Might want to email them to see if they carry them and will sell just the fitting.
|
Interesting, I didn't consider using a banjo fitting. I know the OEM feed is banjo.. That's an option, though I would prefer a strait connection. Thanks
|
Originally Posted by saedrin
(Post 465987)
IThat's an option, though I would prefer a strait connection.
Or, cut the -3AN end off of a steel fitting, get a 10x1.5mm steel bolt, drill a hole through the center of it, and weld the fitting to the bolt head. I've seen it done. |
I use a banjo fitting for my oil feed at -3AN. Works great.
|
Jayc72 The bolts for banjo fittings flow enough oil?
|
I run a .035 restrictor. You should be worried about too much oil, not the other way around.
|
Yeah, I've been running a banjo feed with my journal-bearing, non-water-cooled Mitsu turbo for 4 years now. In fact, I'm using banjos on both ends of the supply line- at the block, and also at the CHRA itself. No track events, granted, but it doesn't get coddled.
|
contact Artech he has them. btw you need to search more
|
Originally Posted by p51hellfire
(Post 466260)
contact Artech he has them. btw you need to search more
|
Originally Posted by Savington
(Post 466247)
I run a .035 restrictor. You should be worried about too much oil, not the other way around.
|
All times are GMT -4. The time now is 09:44 AM. |
© 2024 MH Sub I, LLC dba Internet Brands