OK something else broke
My good damn oil feed fitting broke on me. I believe it is m10*1.25 to 4 an anyone know where i can get one that isnt alluminum the threads on the an side just desintigrated on my when i went to tighten it after i noticed some leaking. this damn car is so close but at the last second it fights me lol.,
|
call AN Plumbing or Paragon Performance and ask them about a steel replacement.
|
I MIGHT be wrong here, but I thought that the fitting on the block was M10x1.5, not M10x1.25.
I do recall that when I was doing my original setup, I never was able to find a straight fitting to go into the block and give me an AN outlet. So instead, I used a brake banjo fitting. They're available in both straight & angled, and while I can't remember exactly which one I used, the gist was something like this with one of these screwed into it. (Don't forget the washers.) Yeah, it's -3AN instead of -4. Works fine. |
Joe's right, my build sheet shows M10x1.5 as well. I used Paragon Performance pn PP-2966.
|
its not from the block its from my AN feed line int the top of my 16g.
|
i got another from summit same alluminum shit atp had steel but it was gonna end up being like 50 bucks all said and done and that is outrageus imo. 4 an to 12x1.25 should not be that damn expensive.
|
All times are GMT -4. The time now is 12:18 PM. |
© 2024 MH Sub I, LLC dba Internet Brands