Porting MSM manifold
4 Attachment(s)
I am about to do the final install of the MSM turbo setup. Looking at the ports where the exhaust gases enter the turbo manifold I noticed that the geometry reduces down right after the gasket and then opens up.
https://www.miataturbo.net/attachmen...1&d=1398089777 https://www.miataturbo.net/attachmen...1&d=1398089604 Is there any reason I can't just port this lip out to keep the exhaust flow smooth and not hit this speedbump on the way to the turbo? I am sure it is in there because of the casting process. I do not want to weaken the manifold and have cracks later. It appears that there should be more than enough material left though. Anyone with MSM experience deal with this before? |
You might check with the guys on Mazda-Speed.com. If there are any tricks with the MSM stuff, those guys will know them.
My wild ass uninformed opinion is to PORTALLTHETHINGS because its cast, but that's just me ;) |
Do it....no reason I can see why not
|
All times are GMT -4. The time now is 10:27 PM. |
© 2024 MH Sub I, LLC dba Internet Brands