Problems with panel meter wideband gauge.
https://lh6.googleusercontent.com/--...283%252529.JPG
What am I doing wrong here? Ive got it set up to read as 10:1 as 1v and 19.99:1 as 2v but the output 2 wire is only putting out .04 (confirmed with volt meter) The wideband is reading correctly on output 1 and in logworks but just cant get the wire for the gauge to work right. (gauge reads 1.2v as 12v) Any ideas? |
Have you tried using the other output just to test? I've heard of LC-1s screwing up one of the outputs before.
How much was that panel display? The only one I could find was outrageously expensive so I rolled my own: |
I tested it, it's putting out 3 something at idle I believe? Idk it's working properly but didn't want to unwire the megasquirt.
http://www.ebay.com/itm/Mini-99-9VDC...#ht_5874wt_897 Just sent the seller an email and asked for decimal to be adjusted. They have great cust service, it just takes a couple weeks for shipping |
Sooo... bringing this back from the dead. Would there be any harm in attaching the display to the working output and just setting the main output to 1-2v=10-20 afr and just telling the ms to use that? I noticed that in tunerstudio there is an option for "innovate 1.0-2.0" would this possibly be the same thing?
|
I think you'll lose resolution, megasquirt inputs are setup for 0-5 volts... and going 1-2 volt effectively limits the precision by a fifth.
|
All times are GMT -4. The time now is 08:05 AM. |
© 2024 MH Sub I, LLC dba Internet Brands