problems setting timing
 

i cann't get my damn timing set :vash: car is a 1.6, brand new NGK plugs and wires. warmed it up, turned it off, jumped TEN and GND, started the car back up. with the light on #1 or #4, you cant see the timing mark on the pulley at all. with the timing light on #2 or #3, it is close to where it should be, but not close enough. with the CAS turned clockwise all the way if you standing in front of the car it will be a 10 BTDC. but the car doesnt want to rev at all. i have no clue whats going on, any idea? and there is NO CEL on.

firing order is like this if you standing in front of the car

3 2 1 4 coil pack

4 engine
3
2
1

im useing an few year old harbor frieght adjustable light, i think that could be part of the problem

yo bryan i got a timing light i just bought, want me to bring it by this weekend?

who did the timing belt last? If the timing belt is off then the timing is probably off too. Check if timing belt,intake, and exhaust cam position with the engine at TDC. Also try using rollin904s timing gun.

car ran WAY to strong pre-turbo for the timing to be off.

and TJ, if it doesnt rain tomorow afternoon or this weekend, i will be giveing you a call man

physically rotate the crank by hand. 21mm on pulley.

turn until the timing mark on the pulley reaches TDC.

remove the spark plug from #1 and see if the piston is in fact TDC.

it's looking like it's gonna rail all damn weekend though :(

i actually did that today. turns out i have mutliple marks on the pulley, and the right one was actually so faint you can barley see it, and it was cut near the inside lip so it was hidden under the timing cover :vash:. it now has some bright green paint on the mark. i will try and time it after i finish the IC pipeing and it stops raining .......again

it helps when you can actually see the mark. timing is now set at 6 btdc. now have other issues to sort out, i might post another thread about the new problem later