Q about compressor wheel and housing (60mm 62trim)
ok so the short version is "I want to try a smaller compressor".
the long version is: will a 60mm 62 trim wheel and housing bolt to my 2876R's CHRA? I haven't looked much at how it fits up yet but I'm hoping for an easy swap. whee! oh and I think that this will make it a GT2860R. If that helps. |
I have nothing of value to add but why do you want to go smaller?
|
his dick got bigger, so their is no need to run an excessively over sized turbo for his power level?
|
If paul is pulling 300 rwhp on a 2560 and has boost in the low 2000 rpms.... why the heck not?
I'm sure it's not an expensive test and may allow more smoky burnouts. |
Teehee m@, didn't I always advocate the "smallest turbo for your realistic max hp goal", for a street car? ;)
|
i don't see why it wouldn't work....so long as the housing is made for the wheel.
...the backplate will be machined for your 71mm wheel, but i don't see that posing an issue. you'll just have a 5.5mm dead space around the wheel. http://www.boostedmiata.com/t3_turbo...rebuild001.jpg you can see my backing plate...if you can't understand my jibber jabber. |
hell dude, for the price, just buy this:
http://cgi.ebay.com/ebaymotors/T3-SU...mZ380050836442 then give me the turbine housing and wheel :) |
All times are GMT -4. The time now is 08:53 PM. |
© 2024 MH Sub I, LLC dba Internet Brands