Stripes Pipes - 2 years later
So today I had some free time and decided to leave work a bit early. I have gotten a bit sick of how nasty my Stripes pipes kit has gotten over the years. The paint never adhered very well. So I pulled all the pipes and got to work. Stripped them all down with a wire wheel until nice and shiny. As I wrapped up my work, my wire wheel decided to end it all and throw itself out of the drill and over my 12th floor balcony...woops.
Now the question is: Should I clear them and leave them shiny? Should I paint them flat black and never have to clean them again? Also, when painting IC pipes can I get away with interior trim paint black (I have 2 cans) or should I use the engine enamel? http://i40.tinypic.com/2aexs0y.jpg http://i39.tinypic.com/r0z3o4.jpg http://i40.tinypic.com/2r639yb.jpg http://i40.tinypic.com/2zhkxzt.jpg |
That's what I did with mine, I cleared them. But over the winter they started showing signs of rust.
you should just get them PCed. :P |
Originally Posted by Braineack
(Post 381579)
That's what I did with mine, I cleared them. But over the winter they started showing signs of rust.
you should just get them PCed. :P |
trim paint would work on the cold side, probably not the hot side. Just get a can of paint meant for engine blocks if you end up painting it.
|
Pc...fo sho
|
Barbecue black from the hardware store has stuck to everything I've ever painted. But it's flat black.
|
Originally Posted by m2cupcar
(Post 381632)
Barbecue black from the hardware store has stuck to everything I've ever painted. But it's flat black.
However, the rustoleum I used on my valve cover is surviving really well actually. That'd be my advice...do rustoleum in the color you want and you should be good. Pretty durable, lots of colors to choose from, easy to apply and looks good. |
duplicolor ceramic high-temp paint lays down awesome on that shit.
|
just be sure to use a good metal etching primer first, and you will never have any problems.
|
I opt'd to say hell with it: I'll just PC and not risk it chipping off and going through this crap again. My VCover is PC'ed Mirror Silver, and the new BEGI IM is aluminum, so i suppose I'll do the same color.
|
i work at a powdercoating shop. we've had customers smooth welds with jb weld. if you sand it down to a thin layer it shouldnt boil, the powder just wont stick to it very well since its not conductive . that is if they used regular jb weld. the kwik stuff sucks.
|
Originally Posted by Newbsauce
(Post 381590)
Blah.. I'm considering it, but then i need to remove the sensor that someone JB welded on the thread a bit :bang: haha
I thought we JB welded an adapter in the pipes then simply screwed in the sensor... |
All times are GMT -4. The time now is 03:57 AM. |
© 2024 MH Sub I, LLC dba Internet Brands