T-fitting for DIY fuel rail
I found a shop, where I could buy something like this
http://www.facet-pumpen.de/120x120/3-10mm.jpg or that http://www.facet-pumpen.de/120x120/TStueck.jpg for my DIY fuel rail. It's made for tube diameters of 8mm (like 5/16"). Any problem with that? I just ask because it looks way simpler than the original solution. Greets |
I'm using one that looks like the lower one. But I doubt it would really matter which one.
|
if i had the choice i'd used the top one just cause its easier to route with it...otherwise its all the same.
|
Is Schwarzenberg where the black people live?
Oh and it doesnt matter, whichever gives you the better seal. |
Originally Posted by Saml01
(Post 229990)
Is Schwarzenberg where the black people live?
No, it's where the russians found enough uranium to build a lot of A-bombs after WW2, because you didn't want us... http://en.wikipedia.org/wiki/Free_Re..._Schwarzenberg :vash: Greets |
Yea.... To take over the world.
Its a good thing too, cause now we will... the Jews. :giggle: --- Btw, just noticed you have a NB with a 1.6. I just read about how mazda produced that engine into the later years in some markets. Does it have the oil port on the block? |
Sorry, I can't help you there, I had my kit installed.
Greets |
All times are GMT -4. The time now is 09:10 PM. |
© 2024 MH Sub I, LLC dba Internet Brands